Table of Contents
Advertisement
The lamp should be replaced when it reaches the end of its life (typically 1,300 hours), or
sooner if a noticeable degradation in brightness occurs.
Keep track of the number of hours the lamp has been in use and be aware of any changes
to brightness. These indicators will help you effectively maintain operation of the projector.
To find out how long the currently-installed lamp has been in service, select Display Info.
from the Display Device - Configure menu (available by selecting Service -> Display
Device -> Configure -> Display Info., in sequence).
For lamp replacement, please contact your nearest Runco authorized service
center or Runco dealer. Do not attempt to replace the lamp yourself!
1. Remove the two screws securing the Left (Exhaust) Side Panel (see Figure 2-2) to the
projector. Then, remove the panel.
2. To open the lamp compartment cover: Using a Phillips screwdriver, turn the
captive screw on the lamp compartment cover counter-clockwise to access the lamp
compartment (see Figure 5-1). When the door is open, the lamp automatically turns
off.
Lamp Compartment Cover
Retaining Screws
Figure 5-1. Opening the Lamp Door
3. Wait at least 10 minutes to allow the lamp to cool before handling it!
4. Remove the old lamp.
a Unscrew the three (3) captive screws securing the lamp using a #1 Phillips
screwdriver.
b Carefully remove the lamp from the projector. Place the old lamp in a location where
it cannot fall or be bumped.
D-113d Projection System Installation/Operation Manual
5. Maintenance and Troubleshooting
Lamp 1
Lamp 2
97
Maintenance and Troubleshooting
5.1
Lamp Replacement
Advertisement
Table of Contents
Troubleshooting
