Power-Up Sequence And Optical Alignment Procedure - Runco 3Dimension D-113d Installation & Operation Manual

At this point you are ready to perform the initial power-up sequence and optical alignment
procedure, which is summarized in Table 3-6 and described in detail in the sections that
follow.
This procedure assumes the following:
• You are installing a projector equipped with anamorphic lenses. (If not, you can skip
those tasks relating to the anamorphic lenses.)
• You have already completed the physical installation of the projector, DHD Controllers
and 3Dimension Processor as described in the previous sections. If you have not, do
so now.
• You have connected the various system components to each other, to external
equipment and to AC power. If you have not, do so now.
Table 3-6. D-113d Optical Alignment Procedure (with Anamorphic Lenses)
START
DHD
1. Leave system off for now.
2. Connect an active 1080p source to the
HDMI 1 connector.
DHD
1. Turn on system and select the HDMI 1
input.
2. Select Aspect Ratio and set it to 16:9.
3. To clear any previously-set "warp" (image
alignment) values, select Service ->
System Reset and choose Yes to reset the
system to the factory default state.
4. Select Calibration -> Adjustment Mode
and set it to Primary.
5. Select Service -> Display Device ->
Configure -> Lens.
D-113d Projection System Installation/Operation Manual
Projector
1. Mount the projector (refer to
Mounting the D-113d on page 32).
2. Mount the DHD Controllers and
3Dimension Processor (refer to
Mounting the DHD Controllers
and 3Dimension Processor on
page 34).
3. Connect system components to each
other and to external equipment (refer
to System Interconnections on
page 35).
Projector (Align Primary/Left Image
with Screen)
1. Cover the bottom projector lens.
2. Adjust Focus using the focus test
pattern.
3. Adjust Zoom and Position using the
outer edge of your image as a guide.
Make sure your source is using the
entire 1080p frame. A 100% white
image would be best for this step.
You may need to readjust Focus after
this step.
4. Remove the cover from the bottom
projector lens and place it on the top
projector lens.
49
3.10
Power-Up Sequence
and Optical Alignment
Procedure
Note: You must enter a passcode to
access the Calibration or Service menu.
Installation