Ricoh MV310E Operator's Manual page 177

USA
FCC Requlremmts
1. This equipment complies with Part 66 of the FCC rules. On the cover of this equipment is a label that contains, among other
information, the FCC registration number end ringer equivalence number (REN) for this equipment. If requested. this information
must be provided to the telephone company.
2. This equipment uses the tollowing USOC jack: RJllC
3. The REN is used to determine the quantity of dewces which may be connected to the telephone line. Excessive REN's on the
telephone line may result in the devices not rnging in response to an incoming call. In most, but not all areas, the sum of the REN's
should not exceed five (5.0). Contact the telephone company to determine the manmum REN for the calling area.
4. If this equipment causes harm to the telephone network, the telephone company will notify you in advance that temporary
discontinuance of service may be required. If advance notice is not practical, the telephone company will notify the customer as
soon as possible. Also, you will be advised of your right to file a complaint with the FCC if you believe it is necessary.
5. The telephone company may make changes in its facilities. equipment, operations, or procedures that could affect the operation
of the equipment. If this happens. the telephone company will provide advance notice in order for you to make necessary
modifications in order to maintain uninterrupted service.
6. In the event of operation problems (document jam, copy jam, communication error indication). refer to the solving problems
section in this manual.
7. It you cannot correct the problem, please contact the RICOH CORP. CUSTOMER SUPPORT DEPT. at l-600-FASTFIX for
repair and warranty information. If it is causing harm to the telephone nelwork. the telephone company may request you to
disconnect the equipment from the network until the problem is resolved.
8. This equipment cannot be used on telephone company-pronded coin service. Connection to Party Line Service is sublect to
state tariffs.
WHEN PROGRAMMING EMEAGENCY NUMBERS AND/OR MAKING TEST CALLS
TO EMERGENCY NUMBERS:
1. Remain on the line and briefly explam to the dispatcher the reason for the call before hanging up.
2. Perform such activities in the off-peak hours, such as early morning hours or late evenings.
CANADA
The Industry Canada label identitles certified equipment. This certification means that the equipment meets certain
telecommunications network protective, operational. and safety requirements. The depatiment does not guarantee the equipment
will operate to the user's satisfaction. Before installing this equipment. users should ensure that it is permissible to be connected to
the facilities of the local telecommunications company. The equipment must also be installed using an acceptable method of
connection. The customer should be aware that compliance with the above condrtlons may not prevent degradation of Service in
some situations.
Repairs to cerlified equipment should be made by an authorized Canadian maintenance facility designated by the supplier. Any
repairs or alterations made by the user to this equipment, or equipment malfunctions. may give the telecommunications company
cause to request the user to disconnect the equipment. Users should ensure for their own protection that the electrical ground
connections of the power utility. telephone lines, and internal metallic water pipe system, if present, are connected together. This
precaution may be particularly important in rural areas.
Caution: Users should not attempt to make such connections themselves, but should contact the appropriate electric inspection
authority, or electrician, as appropriate.
The standard connecting arrangement code for this equipment is CA11 A.
The Load Number (LN) assigned to each terminal device denotes the percentage of the total load to be connected to a telephone
loop which is used by the device to prevent overloading. The termination of a loop may consist of any combination of devices subject
only to the requirement that the sum of the load numbers of all the devices does not exceed 100.