Grinder Adjustment - Rancilio EGRO 5511 Technical Manual

EGRO 5511 Manual

GRINDER ADJUSTMENT

1. 1.
Remove the screw holding the front door in
place ( ).
P12
Swing the front door open.
2. 2.
Looking inside the machine, you will see the two
grinders ( ).
P13
Located on top of both grinders is an adjustment
plate.
3. 3.
Insert a standard screwdriver into the slot on
the adjustment plate (
Apply gentle downward pressure on the screw-
driver to lift the plate free of the notches that are
holding it in place.
4. 4.
Turn the bean hoppers on top of the Egro 5511
to adjust the grinder burrs.
FINER GRIND = Turn hoppers clockwise
COARSER GRIND = Turn hoppers counter-
clockwise
Make sure that the adjustment plate is securely
held in place by the notches before removing the
screwdriver from the slot.
Note: While one notch is a seemingly small adjustment, it can
greatly affect the resulting grind. Use small turns, one notch
at a time, to adjust the grinder burrs until the correct grind is
reached.
).
P14
P
1
2
P
1
3
P
1
4
Front door screw
Grinders
Screwdriver
in grinder
adjustment
plate slot
Page 14