Grinder Burr Replacement - Rancilio EGRO 5511 Technical Manual

EGRO 5511 Manual

GRINDER BURR REPLACEMENT

Grinder Burr Replacement
1. Turn off the machine and unplug
2. Remove the bean hoppers
3. Remove the top panel
a. This requires all 3 side panels need to be removed; after the screws are removed
4. Remove Locking plate
a. To do this; remove the two standard screws.
5. Unscrew the upper burr plate by rotating in a counter-clockwise motion.
6. Remove old burrs
a. Remove the 3 standard screws on each burr; the upper burr plate that was removed and the
Burr in the bottom of the grinding chambers. Note that the upper burr on the top panel is different and
the new burr must match.
7. Clean upper and lower burr plate
8. Install new burrs.
9. Re-insert the upper burr plate into grinding chamber.
a. Screw in till the burrs touch then back off ¼ turn.
10. Re-assemble the top plate and the side panels
11. Turn the machine
a. Allow the machine to reach operating temperature.
12. Check the Grind in the "Tech menu/ Config 1/ Grinders/ Test
a. Achieve a espresso grind
13. Dial in the 10 grams
Page 64