Power On; De-Pressure Steam Boiler; Remove Programming Keys - Rancilio EGRO 5511 Technical Manual

EGRO 5511 Manual

POWER ON

Ensure that the main water supply is open and
feeding water to the machine. Plug the machine
into the wall electrical receptacle. To turn on the
Egro 5511, follow these steps:
· Raise the coffee spout to its highest position
· Move the TS steam wand to the left
· Open the grounds access door (
· Remove the plastic grounds tray
· Toggle the power switch to the ( | ) position (
Finally, replace the plastic grounds tray and close
the access door.
*ATTENTION: Do not attempt to program the machine until the machine is ready*
When the machine is turned on, it must go through an initialization. During this time do not enter programming,
otherwise an error may occur. You may enter programming after the screen reads "Please Select".
DE-PRESSURIZE STEAM BOILER
(This step is very important because the steam boiler
MUST de-pressurize before it can function correctly.)
After turning on the Egro 5511, press the TS
wand activation button.
Do not try to manipulate the programming of the
Egro 5511 while it is de-pressurizing. You may
only enter programming after the machine has
fully de-pressurized.
Note: If "Error 33" appears on the display screen, turn the
machine off – wait 10 seconds – then turn it back on.
When steam begins to exit the wand, press the
TS wand activation button again to stop the flow
of steam.
)
P10
)
P11

REMOVE PROGRAMMING KEYS

Remove the bag containing the programming
keys from around the hot water spout.
P
1
0
P
1
1
Front view,
grounds access
door open
Power switch
Page 13