Table of Contents
Advertisement
EGRO 5511 Manual
BREW GROUP REPLACEMENT
Complete Brew Group Assembly Replacement
1.
Unplug machine
2.
Remove the Left side panel to gain access to the mother board.
3.
Disconnect the Motors from the motherboard
a.
Connections "J2" & "J3" located in the up right hand side of the motherboard.
4.
Disconnect the John Guest fittings on the upper and lower piston
5.
Loosen the 2 nuts located behind the B.G.A.
6.
Pull the B.G.A. upwards to remove from the door.
7.
Clean any coffee build up on the B.G.A.
8.
Install the new B.G.A.
a.
Reverse Directions stated above.
*CAUTION*
Ensure that both John Guest fittings are fully seated and sealed. Failure to do so may result in water
damaging electrical components!
Page 61
- Quick Links:
- Section 3: Programming
Hide quick links:
Advertisement
Table of Contents
