-c
(Display Configured Port Settings)
To view the configured settings for the port, issue the -c command as follows:
-c [hba_port_inst]
When you specify a port instance, information for only that adapter is shown.
When you do not specify a port instance, information for all adapter ports in the
system is shown.
-ch
(HBA Information)
To display the adapter's configured settings, issue the -ch command as follows:
-ch [hba_port_inst]
When you specify a port instance, information for only that adapter is shown.
When you do not specify a port instance, information for all adapter ports in the
system is shown.
-chapmap
(Display Targets Using CHAP Entries)
To display the map of targets to CHAP table entries, issue the -chapmap
command as follows:
-chapmap <hba_port_inst>
-cpbootcode
(Clear Primary Boot Target Information)
To clear the primary boot target and LUN, issue the -cpbootcode command as
follows:
-cpbootcode <hba_port_inst>
NOTE:
This command is not active for the PPC.
-csbootcode
(Clear Secondary Boot Target Information)
To clear the secondary boot target and LUN, issue the -csbootcode command
as follows:
-csbootcode <hba_port_inst>
SN0054667-00 B
6–iSCSI Noninteractive Commands
-c (Display Configured Port Settings)
6-5