(Display Version); (Virtual Port) - Qlogic 2400 Series User Manual

5–Fibre Channel Noninteractive Commands
-v (Display Version)
-v

(Display Version)

NOTE:
This option is valid only in noninteractive mode.
To show the version number of the QConvergeConsole CLI utility, issue the
following command:
# qaucli -pr fc -v
The system shows the following information:
QConvergeConsole CLI
v1.x.x Build x
Copyright 2003-2009 QLogic Corp.
All rights reserved.
Command Line QLogic FC Host Bus Adapters.
Build Type: Release
Build Date: xx/xx/xxxx xx:xx:xx AM
-vp

(Virtual Port)

To list all virtual ports on a physical adapter port, issue the following command:
# qaucli -pr fc -vp (<hba instance> : <hba wwpn>) list all
Where:
hba instance = Adapter number (use -g command to find)
To list a specific virtual port on a physical adapter port, issue the following
command:
# qaucli -pr fc -vp (<hba instance> : <hba wwpn>) list <vport wwpn>
To create a virtual port with an automatic WWPN, issue the following command:
# qaucli -pr fc -vp (<hba instance> : <hba wwpn>) create auto
5-36
hba wwpn = World wide port name of the adapter
vport wwpn = World wide port name of the virtual port
vport hex = World wide port name of the virtual port with the two
hex digits in byte three supplied by the user
SN0054667-00 B