(List Fibre Channel Error Codes); (Input Parameter Options From A Text File) - Qlogic 2400 Series User Manual

QConvergeConsole CLI checks all parameters to verify that the adapter, targets,
and LUNs are valid.
If you select an adapter with no target or a target with no LUN,
QConvergeConsole CLI shows an error message and aborts.
For all operating systems, if the adapter already has boot devices defined and
they are different from the ones in the command parameter or menu selection,
you are prompted to confirm the boot device selection:
The HBA already has a boot device(s) selected. Do you want to
replace it with the new one?
For all operating systems, if the adapter already has boot devices selected and
they are the same as the ones in the command parameter or menu selection, the
following message appears:
The HBA already has that device selected as boot device.
To use selectable boot (the OS boots from the first target the BIOS finds) set the
<target wwpn>, <target wwnn> and <lun id> inputs to all zeroes. For example
issue the following command:
# qaucli -pr fc -e (<hba instance> | <hba wwpn>) (enable | 0 0 0)
To disable (delete) the boot device for a specific adapter, issue the following
command:
# qaucli -pr fc -e (<hba instance> | <hba wwpn>) disable
-ei

(List Fibre Channel Error Codes)

This command lists the Fibre Channel error codes.
-f

(Input Parameter Options from a Text File)

NOTE:
The -f option is valid only in noninteractive mode, and cannot be combined
with any other options. Only one command line parameter per file is valid.
This option is used when it is run as a script file.
To input parameter options to QConvergeConsole CLI through a text file, type -f,
followed by the file name. For example:
# qaucli -pr fc -f command.txt
The text file must be formatted as follows:

The file must contain a single line.
SN0054667-00 B
5–Fibre Channel Noninteractive Commands
-ei (List Fibre Channel Error Codes)
5-11