(Show Driver Settings); (Configure Driver Settings) - Qlogic 2400 Series User Manual

5–Fibre Channel Noninteractive Commands
-fg (Show Driver Settings)

The file must contain only parameters.

The file cannot contain another -f option.
The following example shows how to set the connection option of an adapter to
default (loop preferred, otherwise point-to-point) and the data rate to auto through
a command file that is invoked by the -f option:
1. Create a text file (for example, setadapter0.txt) and enter the following
command in the text file:
-n 0 co 2 dr 2
2. Save and close the file.
3. Issue the qaucli -pr fc command with the -f option (input from
command file):
# qaucli -pr fc -f setadapter0.txt
# qaucli -pr fc -f <file name>
QConvergeConsole CLI specifies command line input from file.
-fg

(Show Driver Settings)

NOTE:
The -fg option is valid only in noninteractive mode.
To show the driver settings, issue the following command:
# qaucli -pr fc -fg (<hba instance> | <hba wwpn>) (view | info)
Where:
-fs

(Configure Driver Settings)

Type the following command to configure the driver settings:
# qaucli -pr fc -fs (<hba instance> | <hba wwpn>) {(<param name> |
<param alias>) <param value>}
5-12
hba instance = Adapter number (use -g command to find)
hba wwpn = World wide port name of the adapter
SN0054667-00 B