Type; Minbw; Protocol; Restore To Non-Nic Partition Settings - Qlogic 8200 Series User Manual


Boot LUN
Enter to specify the LUN of the boot device. (Depending on your
configuration, it may not be necessary to change this option.)

CHAP Type




Target CHAP Name
Enter to specify the target CHAP name.

Target CHAP Secret
Enter to specify the target CHAP secret.

Type

Enter to set a function to a particular type.
 NIC—NIC protocols will be supported.
 None—The function will be disabled.
 iSCSI—The function will support iSCSI protocol.
 FCoE—The function will support FCoE protocol.
NOTE:
Functions 0 through 3 support only NIC or None. Functions 4 and 5 support
NIC, iSCSI, or None. Functions 6 and 7 support NIC, FCoE, or None.

MinBW%

Enter to specify the percentage of bandwidth allocated to the function. The
combined MinBW% values for a port's functions cannot exceed 100 percent.

Protocol

The Protocol parameter applies only to only function 0 and function 1.
 PXE—PXE will be supported on the NIC.
 iBFT—iBFT will be supported on the NIC.
NOTE:
For an embedded LOM, the Protocol parameter is controlled by the system
BIOS and is non-configurable in the CNA Function Configuration utility.

Restore to Non-NIC Partition Settings

Press the ENTER key to restore the NIC partition settings.
SN0054671-00 A
Multi-boot Image for 10Gb CNA—CNA Function Configuration Utility
None—CHAP is not used.
One-Way—Unidirectional CHAP is used.
Mutual—Bidirectional CHAP is used.
1–Product Overview
1-11