A
CAUTION!
If you are using the 10-Gbps ports, remove the port covers by the cover tabs using
your fingers or pliers as shown in
To install XPAK switch stacking cables, position the cable connectors with the
circuit board toward the mid line of the respective switch faceplates as shown in
Figure
cable connectors into the 10-Gbps ports at the same time.
Circuit Board
Figure 4-5. Installing XPAK Switch Stacking Cables
59096-02 C
To maintain proper air flow and prevent the switch from
overheating, keep covers installed in unused 10-Gbps ports.
Figure 4-4. Removing 10-Gbps Port Covers
4-5. When installing the 3-inch XPAK switch stacking cable, insert the
Figure
4-4.
4 – Installation
Installing a Switch
4-7