Qlogic SANbox 5600 Series Installation Manual page 221

A
PendingImageVersion - build date
ActiveConfiguration
AdminState
AdminModeActive
BeaconOnStatus
OperationalState
PrincipalSwitchRole
BoardTemp (1) - Degrees Celsius
SwitchDiagnosticsStatus
SwitchTemperatureStatus
timezone
Displays the current time zone setting.
topology
Displays all connected devices.
users
Displays a list of logged-in users. This is equivalent to the User List command.
version
Displays an introductory set of information about operational attributes of the
switch. This keyword is equivalent to the About keyword.
59096-02 C
Table B-28. Switch Operational Parameters (Continued)
Parameter
B – Command Line Interface
Description
Firmware image version and build date
that is pending. This image will become
active at the next reset or power cycle.
Name of the switch configuration that is in
use.
Switch administrative state
Admin session status
Beacon status as set by the Set Beacon
command.
Switch operational state
Principal switch status. True indicates that
this switch is the principal switch.
Internal switch temperature at circuit board
sensor 1
Results of the power-on self test
Switch temperature status: normal, warn-
ing, failure
Show Command
B-99