Qlogic SANbox 5600 Series Installation Manual page 210

B – Command Line Interface
Set Setup Command
LocalLogEnabled
RemoteLogEnabled
RemoteLogHostAddress
NTPClientEnabled
NTPServerAddress
EmbeddedGUIEnabled
B-88
Table B-26. System Configuration Settings (Continued)
Entry
Enables (True) or disables (False) the saving of log infor-
mation on the switch. The default is True.
Enables (True) or disables (False) the recording of the
switch event log on a remote host that supports the sys-
log protocol. The default is False.
The IP address of the host that will receive the switch
event log information if remote logging is enabled. The
default is 10.0.0.254.
Enables (True) or disables (False) the Network Time Pro-
tocol (NTP) client on the switch. This client enables the
switch to synchronize its time with an NTP server. This
feature supports NTP version 4 and is compatible with
version 3. An Ethernet connection to the server is
required and you must first set an initial time and date on
the switch. The synchronized time becomes effective
immediately. The default is False.
The IP address of the NTP server from which the NTP cli-
ent acquires the time and date. The default is 10.0.0.254.
Enables (True) or disables (False) the SANsurfer Switch
Manager Web applet. Changing this parameter to False
while the applet is running will terminate the applet. The
default is True.
Description
S
59096-02 C