Image Command - Qlogic SANbox 5600 Series Installation Manual

B – Command Line Interface

Image Command

Image Command
Manages and installs switch firmware.
Authority
Admin session
Syntax
image
cleanup
fetch [account_name] [ip_address] [file_source] [file_destination]
install
list
unpack [file]
Keywords
cleanup
Removes all firmware image files from the switch. All firmware image files are
removed automatically each time the switch is reset.
fetch [account_name] [ip_address] [file_source] [file_destination]
Retrieves image file given by [file_source] and stores it on the switch with the file
name given by [file_destination]. The image file is retrieved from the FTP server
with the IP address given by [ip_address] and an account name given by
[account_name]. If an account name needs a password to access the FTP server,
the system will prompt you for it.
install
Downloads firmware from a remote host to the switch, installs the firmware, then
resets the switch (without a power-on self test) to activate the firmware. This reset
is disruptive. The command prompts you for the following:
IP address of the remote host
An account name and password on the remote host
Pathname for the firmware image file
list
Displays the list of image files that reside on the switch.
unpack [file]
Installs the firmware file given by [file]. After unpacking the file, a message
appears confirming successful unpacking. The switch must be reset for the new
firmware to take effect. Enter the Hotreset command to attempt a non-disruptive
activation.
B-38
S
59096-02 C