Qlogic SANbox 5600 Series Installation Manual page 262

B – Command Line Interface
Zoning Command
save
Saves changes made during the current Zoning Edit session. The system informs
you that the zone set must be activated to implement any changes. This does not
apply if you entered the Zoning Clear command during the Zoning Edit session.
Examples
The following is an example of the Zoning Edit command:
SANbox #> admin start
SANbox (admin) #> zoning edit
SANbox (admin-zoning) #>
.
.
SANbox (admin-zoning) #> zoning cancel
Zoning edit mode will be canceled.
SANbox (admin) #> admin end
The following is an example of the Zoning Limits command:
SANbox #> zoning limits
Zoning Attribute
----------------
MaxZoneSets
MaxZones
MaxAliases
MaxTotalMembers
MaxZonesInZoneSets
MaxMembersPerZone
MaxMembersPerAlias
B-140
Please confirm (y/n): [n]
Maximum Current [Zoning Name]
------- ------- -------------
256 6
2000 17
2500 1
10000 166f
2000 19
2000
10 D_1_JBOD_1
23 D_1_Photons
9 D_2_JBOD1
16 D_2_NewJBOD_2
5 E1JBOD1
5 E2JBOD2
3 LinkResetZone
3 LinkResetZone2
8 NewJBOD1
8 NewJBOD2
24 Q_1Photon1
8 Q_1_NewJBOD1
13 Q_1_Photon_1
21 Q_2_NewJBOD2
3 ZoneAlias
3 ZoneDomainPort
4 ZoneFCAddr
2000
2 AliasInAZone
S
y
59096-02 C