Securityset Command - Qlogic SANbox 5600 Series Installation Manual

B – Command Line Interface

Securityset Command

Securityset Command
Manages security sets in the security database.
Authority
Admin session and a Security Edit session. Refer to the
page B-54
Groups, and List keywords are available without an Admin session. You must
close the Security Edit session before using the Activate and Deactivate
keywords.
Syntax
securityset
activate [security_set]
active
add [security_set] [group_list]
copy [security_set_source] [security_set_destination]
create [security_set]
deactivate
delete [security_set]
groups [security_set]
list
remove [security_set] [group]
rename [security_set_old] [security_set_new]
Keywords
activate [security_set]
Activates the security set given by [security_set]. This keyword deactivates the
active security set. Close the Security Edit session using the Security Save or
Security Cancel command before using this keyword.
active
Displays the name of the active security set. This keyword is available to without
an Admin session.
add [security_set] [group_list]
Adds one or more groups given by [group_list] to the security set given by
[security_set]. Use a <space> to delimit multiple group names in [group_list]. A
security set can have a maximum of three groups with no more than one group of
each group type.
copy [security_set_source] [security_set_destination]
Creates a new security set named [security_set_destination] and copies into it the
membership from the security set given by [security_set_source].
B-58
for information about starting a Security Edit session. The Active,
S
"Security Command" on
59096-02 C