Qlogic SANbox 5600 Series Installation Manual page 181

A
create [security_set]
Creates the security set with the name given by [security_set]. A security set
name must begin with a letter and be no longer than 64 characters. Valid
characters are 0-9, A-Z, a-z, _, $, ^, and -. The security database supports a
maximum of 4 security sets.
deactivate
Deactivates the active security set. Close the Security Edit session before using
this keyword.
delete [security_set]
Deletes the security set given by [security_set]. If the specified security set is
active, the command is suspended until the security set is deactivated.
groups [security_set]
Displays all groups that are members of the security set given by [security_set].
This keyword is available without an Admin session.
list
Displays a list of all security sets. This keyword is available without an Admin
session.
remove [security_set] [group]
Removes a group given by [group] from the security set given by [security_set]. If
[security_set] is the active security set, the group will not be removed until the
security set has been deactivated.
rename [security_set_old] [security_set_new]
Renames the security set given by [security_set_old] to the name given by
[security_set_new].
Notes
Refer to the
managing groups.
Examples
The following is an example of the Securityset Active command
SANbox #> securityset active
Active SecuritySet Information
------------------------------
ActiveSecuritySet alpha
LastActivatedBy
LastActivatedOn
59096-02 C
"Group Command" on page B-26
Remote
day month date time year
B – Command Line Interface
Securityset Command
for information about creating and
B-59