Qlogic SANbox 5600 Series Installation Manual page 218

B – Command Line Interface
Show Command
InvalidDestAddr
LIP_AL_PD_ALPS
LIP_F7_AL_PS
LIP_F8_AL_PS
LIP_F7_F7
LIP_F8_F7
Link Failures
Login
Logout
LoopTimeouts
LossOfSync
PrimSeqErrors
RxLinkResets
RxOfflineSeq
TotalErrors
TotalLIPsRecvd
TotalLIPsXmitd
B-96
Table B-27. Show Port Parameters (Continued)
Entry
Invalid destination address detected.
Number of F7, AL_PS LIPs, or AL_PD (vendor specific) resets,
performed.
This LIP is used to reinitialize the loop. An L_Port, identified by
AL_PS, may have noticed a performance degradation and is
trying to restore the loop.
This LIP denotes a loop failure detected by the L_Port identified
by AL_PS.
A loop initialization primitive frame used to acquire a valid
AL_PA.
A loop initialization primitive frame used to indicate that a loop
failure has been detected at the receiver.
Number of optical link failures detected by this port. A link failure
is a loss of synchronization or a loss of signal while not in the
offline state. A loss of signal causes the switch to attempt to
re-establish the link. If the link is not re-established, a link failure
is counted. A link reset is performed after a link failure.
Number of device logins
Number of device logouts
A two (2) second timeout as specified by FC-AL-2.
Number of synchronization losses (>100 ms) detected by this
port. A loss of synchronization is detected by receipt of an
invalid transmission word.
Primitive sequence errors detected.
Number of link reset primitives received from an attached
device.
Number of offline sequences received. An OLS is issued for link
initialization, a Receive & Recognize Not_Operational (NOS)
state, or to enter the offline state.
Total number of errors detected.
Number of loop initialization primitive frames received by this
port.
Number of loop initialization primitive frames transmitted by this
port.
Description
S
59096-02 C