A
CAUTION!
To maintain proper air flow and prevent the switch from overheating, keep
covers installed in unused XPAK ports.
If you are using the XPAK ports, remove the port covers by the cover tabs using
your fingers or pliers as shown in
To install XPAK switch stacking cables, position the cable connectors with the
circuit board toward the mid line of the respective switch faceplates as shown in
Figure
cable connectors into the XPAK ports at the same time.
Circuit Board
Figure 4-5 Installing XPAK Switch Stacking Cables
59096-06 A
Figure 4-4 Removing XPAK Port Covers
4-5. When installing the 3-inch XPAK switch stacking cable, insert the
Figure
4-4.
4 – Installation
Installing a Switch
4-7