Removing Xpak Port Covers; Installing Xpak Switch Stacking Cables - Qlogic 5800V Series Installation Manual

3–Installation
Installing a Switch
If you are using the XPAK ports, remove the port covers, as shown in
To install XPAK switch stacking cables, position the cable connectors with the
circuit board toward the mid-line of the respective switch faceplates, as shown in
Figure
cable connectors into the XPAK ports at the same time.
Circuit Board
Figure 3-3. Installing XPAK Switch Stacking Cables
3-6
Figure 3-2. Removing XPAK Port Covers
3-3. When installing the 3-inch XPAK switch stacking cable, insert the
Figure 3-2.
59265-02 B