Sharp ViewCam VL-NZ150U Operation Manual page 74

iiiiiiiiiiiiiii!iiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiii!!!iii
iiiii!iilk_iiiiiiiiiiiiiiiiiiiiilil
iiiiiii!!_iiiiiiiiiiiiiiiiiiiiiiii!
_################_
Available mode:
CARD-VCR
You can play back and view still images
recorded on a card on the LCD monitor.
SET button
Media Selection switch
1
2
Operation button
Power switch
Set the Media Selection
switch to CARD.
Hold down the Lock button and set the
Power switch to VCR.
- The images recorded on the card are
displayed in a thumbnail format.
Lock button
_ PLAYBACK 100-0010
NORMAL PAGE 2 i!_
Page number/total thumbnail pages
Press <, >, 'v' or /,, on the Operation
button to move the selection frame to
the desired image.
- Each time you press >, v' or ?,.. the
selection frame moves as shown below.
4 Press the SET button.
- The selected image displays in fulP
screen.
SET
£
Image fib name
1/10
Playback image number/
number of recordings
Picture quality
indicator
Available OpeYatJons during
Full-screen Display
- You can display the fuBscreen picture of the
previous or next image by pressing or >-.
-When holding down < or _--.you can search
through the images on the card. The search
can be very fast, so it is recommended that
the on-screen indicators turns ors to display
the image number.
• To return to a thumbnail of the images, press
the SET button again.
Notes:
o Dependbsg on the amount of data for the
recorded image, the picture quality indicator
displayed during playback may not match the
picture quality setting used during recording.
,, The images bigger than 640× 480, e.g. images
recorded on other equipment, display as
thumbnails, not full screen.
o Do not play back any card storing a defective
image (with noise and distortion) created on
other equipment. If you mistakingly play back
data on such a card, set the Power switch to
OFF, remove, and never use it with this
eamcorder.
PLAYBACK 100-0001
NORMAL PAGE1/2
Note:
" Holding down < or -_ increases the speed
59 of motion of the selection frame.