Sharp ViewCam VL-NZ150U Operation Manual page 73

Available mode:
CARD=CAMERA
Before using a commercially available card
with this camcorder, you must first have it
formatted. Also, if any of the following warning
indicators displays, you will need to format your
card.
- "FORMAT MEMORY CARD"
- "MEMORY CARD ERROR"
- "MEMORY CARD READ ERROR"
- "CANNOT STORE DATA"
Cautions:
o Formatting a card erases aH stored images,
including delete-protected images. Be sure to
backup important data on your computer or
other media before formatting the card (see
pages 65, 66).
o Do not remove the power source during
formatting, as this may cause damage to the
camcorder or card. It is recommended that you
use the AC outlet for the power supply.
1 Insert a card to be formatted into the
camcorder.
In CARD-CAMERA mode, press the
MENU button until the menu screen
appears.
Press _/ or _:, on the operation button
to select ETC,then press the SET button.
4
Press _/ or A to select"FORMAT", then
press the SET button.
- To cancel formatting, press ,7 or ..A, t o
select "NO", then press the SET button.
FORMAT
ALL DATA WILL
BE ERASED.
5
6
Press _/ or A to select"YES", then
press the SET button to begin format-
ting.
- The menu screen displays when
formatting finishes.
Press the MENU button to turn off the
menu screen.
Notes:
o The supplied card is preformatted for immediate
use.
® Use this camcorder to format a card.The
camcorder may not recognize the images on
a card formatted by a computer or other
equipment.
!i!i!i!i!_ii!_!i_ijji
iiiiiiiiiiiiiiii_' ........
58