White Balance Lock - Sharp ViewCam VL-NZ150U Operation Manual

To return to Auto White Balance mode
Available modes:
TAPE-CAMERA, CARD-CAMERA
The color of the subject on the screen looks
different depending on lighting conditions.
Lock the White Balance if the Auto White
Balance does not work properly.
1 In TAPE-CAMERA or CARD-CAMERA
mode, press the MANUAL button until
the white balance setting screen
appears.
2 Aim the lens at a white object.
" Adjust the distance of the object so that
the entire screen is white.
White paper or white cloth
Press the SET button to set the white
balance lock.
- "LOCK" flashes during the locking
procedure.
SET
Note:
o If you move the carncorder while "LOCK" is
flashing, "LOCK" may not stop flashing. If
this occurs, press the SET button to cancel
the procedure, and then repeat step 3.
Press the MANUAL button until the
normal screen appears.
Press the SET button while the white balance
setting screen is displayed.
Note:
o White Balance setting will cancel if a scene
setting is selected thereafter.
To easily record good-qualky images, perform
camera shooting in Full Auto mode. If "AUTO"
is not displayed on the screen, the camcorder
is in Manual mode. Perform the procedure
below to cancel all manual settings and set the
camcorder to Full Auto mode.
In TAPE-CAMERA or CARD-
Gqq
CAMERA mode, press and hold
down the MANUAL button for 2
second.
,, "FULL AUTO" flashes, then stop
flashing when the camcorder is set to Full Auto
mode.
iii!iiiiiiiiiiii_!i_!i_
iiiiii!ii!iii_iiiiiiiil
44