Sharp ViewCam VL-NZ150U Operation Manual page 29

|nsta|iing
The supplied lithium battery is used to store the
memory of the date and time settings.
1 Slide the cassette compartment door
release and open the cassette compart-
ment door.
Note:
o The cassette holder will extend and open
when the camcorder is connected to a
power source. Be sure to close the cassette
holder before proceeding to the next step
(see page 12).
Pull out the lithium battery holder using
a pointed object such as the tip of a
ballpoint pen.
Lithium battery
Insert the lithium
battery into the "_" mark
battery holder with
the + side of the
battery facing the
(_) side of the
holder.
Push the battery holder back into
position. Press the _ mark gently,
then close the cassette compartment
door by pressing the center until it clicks
into place.
Removing
Perform steps 1 and 2 above,
then lift out the battery from
i"
the battery holder.
Notes on the Use of the Lithium battery
REPLACE BATTERY WITH TOSHIBA,
MATSUSHITA OR HITACHI MAXELL TYPE
CR2025 ONLY. USE OF A DIFFERENT
BATTERY MAY PRESENT A RISK OF FIRE OR
EXPLOSION.
KEEP THIS BATTERY AWAY
FROM CHILDREN. IF SWALLOWED, CON-
SULT A PHYSICIAN IMMEDIATELY FOR
EMERGENCY TREATMENT.
I!_ BATTERY MAY EXPLODE IF MIS-
USED OR INSTALLED WITH POLARITY
REVERSED. DO NOT RECHARGE, DISAS-
SEMBLE OR DISPOSE OF IN FIRE.
o Do not short-circuit, recharge, disassemble, or
heat the lithium battery.
o Should the lithium battery leak, wipe the battery
compartment clean, and then insert a new
battery.
o The lithium battery will last about one year under
normal usage.
14