Volume Control - Sharp ViewCam VL-NZ150U Operation Manual

ii};iiiiilililililililililililili@ii!i}iiiiiiii
iiiiiiiiii_iiiiiii!!_!ilililililiiiiiiii!!!
iiiiiiiiiiiiii!_l}}}}}}}}_i_!i_i
Available mode:
TAPE=VCR
The LCD monitor screen functions as a handy
playback monitor. Nothing needs to be
connected, allowing instant on-screen play-
back with the sound through the builtqn
speaker.
Media Selection switch
Operation button
1 Set the Media Selection
switch to TAPE.
2 Hold down the Lock button
and set the Power switch to
VCR.
To stop playback
Press v'.
To turn the power off
Set tile Power switch to OFF without pressing
the Lock button.
Note:
,, The tape is automatically rewound when
playback reaches the end of the tape.
Available mode:
TAPE=VCR
When the camcorder is in TAPE-VCR mode,
push the Volume control to the + or side to
increase (i) or decrease (_) the volume.
The volume level indicator will appear ors the
LCD screen during adjustment only. Once the
Volume control is released, the volume level
indicator will disappear shortly afterwards.
23
Lock button
3 Press < (or >) on the Operation button
to rewind (or fast forward) the tape to the
desired point.
4 Press A to begin playback.
Note:
o If you press the REC START/STOP button in
TAPE-VCR mode, the "_" mark appears and
the camcorder enters Recording Standby mode.
If you do not intend to record, press ,/ to turn
the "@" mark off, then press /., to begin
playback. This will ensure your previous
recording is not erased (see pages 49, 51).
Volume control
[
IIHIIBBBD VOLUME
Decrease _ Increase
Speaker