Sharp ViewCam VL-NZ150U Operation Manual page 66

Advanced Features
Playback
iii!!iiii{{{{iii_!iiiiiiii!ii!illili
iiiii!!iiiiiiiiiii_>>>>!iiii
_ii311_i!_£i;i;i;i;i;i;i{;!
iiiiiiiiiiiiiiiii_iiiii!i@ili
51
Available mode:
TAPE=VDR
This camcorder enables you to perform digital
video editing. Connect the camcorder to video
equipment with a DV terminal using a commer-
cially avaiiabb DV cabb. A DV cabb is abb to
transfer all dubbing signals including video
and audio.
To Record to Video Equipment
See "Cutting Unwanted Sequences" on page
48, using the video equipment as the recording
source.
Note:
o Make sure that the video equipment to which
you are recording can input dubbing signals via
the DV terminal.
To DV termi_ I
Video equipment
with DV terminal
(e.g. DV camcorder)
-- DV cable (commercially available)
To DVterminal _ k_
To Record from Video Equip-
merit
1 Set the camcorder to TAPE-VCR mode,
and insert a Mini DV cassette.
2
3
4
Begin playback on the video equipment
connected to the camcorder.
,, Check the camcorder screen to see if
the picture is properly received.
Press the REC START/STOP button on
the camcorder.
,, The camcorder enters Recording
Standby mode.
Press £ on the Operation button to
begin recording.
To stop recording
Press 'v' on the Operation button.
Cutting Unwanted Sequences
1 Press /,, to pause recording when the
source tape reaches the beginning of
the sequence to be cut.
2 Press /,, to resume recording when the
source tape reaches the end of the
sequence to be cut.
Notes:
e Make sure that the video equipment from which
you are recording can output dubbing signals
via the DV terminal.
,, If the video equipment is not set to playback
mode or the DV cable is not properly connected,
"NO SIGNAL" is displayed on the camcorder
screen.
,, If no picture or sound is input to the camcorder
even if the DV cable is properly connected and
you are playing back the source media from the
video equipment, set the Power switch on the
camcorder to OFF and then back to VCR, or
disconnect the DV cable and connect it again.
o If a digital video recording with a copyright
protection signal is used as the playback source,
"COPYRIGHT PROTECTED." appears on the
camcorder monitor and the recording function is
disabled (see page 72).
,, When displaying the playback picture on the
recording equipment, you may find black bands
around the image. This is caused by the
differences of the image display sizes.
,, You cannot output the picture playing back from
the DV terminal to an external monitor.