Table of Contents
Advertisement
iiii!!!iiii_iiiiii_iiiiiiiiiiiiii
iii!!_i_iiiiiiiiiiiiii
iiiiiiiiiiiiiiii_iiiiiiii!iiii
Attaching
Power switch
i
Make sure that the Power
switch is set to OFR
Align the m
mark on the side of the
battery pack with the ,=,,, mark on the
camcorder
(_),
and slide the battery
pack in the direction
of the arrow
completely
until it locks into place (2}).
Removing
1
Make sure that the Power switch is set
to OFR
2
Rotate the monitor
section of the
camcorder
(_),
then press the battery
release (_).
Slide the battery
pack in
the direction
of the arrow and take it out
(3).
Cautions:
,, BEFORE REMOVING THE BATTERY PACK,
ALWAYS STOP RECORDING OR PLAYBACK
AND TURNTHE POWER OFF. Removing the
battery pack while shooting or during playback
may damage the tape by causing it to wrap
around the video head drum or destroy the card.
rendering it unreadable and unwritable.
,, Remove the battery pack from the camcorder if
you will not use the camcorder for a long period
of time.
,, Make sure that the battery pack is firmly
attached during operation. If it is not, the battery
pack may come off or camcorder operation may
fall because of the poor contact pressure.
,, To prevent damage to the battery pack when
removing, be sure to firmly hold the battery pack
while pressing the release.
,, Use only SHARP model BT-L225 or BT-L445
battery packs with this camcorder. Use of other
batteries may create a risk of fire or explosion.
Hide quick links:
Advertisement
Table of Contents
