Sharp ViewCam VL-NZ150U Operation Manual page 62

iii!!iiii;ii;ii;iiii_liiiiiiiii!ii!i{ili
iiiii!!iiiiiiiiiii_>>>>!liii
_ii311;!_£,i{{{{{{{i,!
iiiiiiiiiiiiiiiii_iii!i!lil!lil!l!i{ii
Available modes:
TAPE-VCR, TAPE-CAMERA
The time code shows the hour. minute and
second of recording, and the frame number
(1 frame = approx. 1/30 sec.). This is automati-
cally recorded along with the subject when you
are recording on the tape. You can display the
time code on the screen as an accurate
counter in both TAPE-VCR and TAPE-CAMERA
modes.
DispJay format
TCO: 00: 10:_2T_
T T T Frame nur'nber*
J |Second
J Minute * Displayed during still
Hour playback.
• The exampb screens shown are for TAPE-VCR
mode.
2
3
5
Press the MENU button to turn off the
menu screen.
- The time code appears when the on-
screen indicators are turned on.
,BU
AUDIO1÷2
Time code
To turn off the time code
Select "DISP. OFF" in step 4 above.
Note:
o When the tape reaches an unrecorded section,
the time code returns to zero (TC0:00:00). Once
recorded, the time code cannot be changed.
DJspJaying the time code on a
TV during pJayback
"J In TAPE-VCR mode, press the MENU
button until the menu screen appears.
2
During playback or camera recording in
TAPE modes, press the MENU button
until the menu screen appears. 3
Press V or /,, on the operation button
to select ETC,then press the SET button.
Press V or ,,Ato select"TIME CODE",
then press the SET button.
Press _y or z1_, on the operation button
to select ETC,then press the SET button.
Press V or A to select"TC OUT", then
press the SET button.
4 Press V or A to select"ON", then press
the SET button.
4 Press _7 or £ to select"DISR ON", then 5 Press the MENU button to turn off the
press the SET button, menu screen.
47