Sharp ViewCam VL-NZ150U Operation Manual page 70

iiiiiiiiiij!ii!iiiiiiii@iiiiiiiiiiiii!!ii
iiii!!!EiiiiiiiR{iiiiiiiiiiiiii
@ii_jljii_iiii!iiiii!ijl
iiiii!!ilk_iiiiiiiiiiiiiiiiiiiiiii
iiiiiii!!_iiiiiiiiiiiiiijii!
_################_
Available mode:
CARD=CAMERA
You can take a still picture in the same way as
you do with a standard camera and record that
image on the card.
STILL button
Power Zoom control
2
3
Lock button
Media Selection : /itc
Pow _r switch
Insert a card into the camcorder (see
page 13).
Remove the lens cap.
Set the Media Selection
switch to CARD.
Hold down the Lock button and set the
Power switch to CAMERA.
- The picture from the lens now displays.
Number of shots taken/remaining
-,,,_/81 I
NORMAL I
AUTO "_
5
6
7
Adjust the Power Zoom control to frame
the subject as you desire.
Press the STILL button half-way down to
focus on the subject.
- The camcorder automatically focuses on
the subject. When it is set, you will hear
a sound and see a mark. then the
camcorder locks the focus.
=_ CARD
9/81
NORMAL
Press the STILL button fully to begin
recording.
AUTO
,,The D indicator flashes red while data
is being recorded on the card, and
returns to white when recording
completes.
,, To record another image, release the
STILL button and make sure the picture
is not frozen in the monitor, then perform
steps 6 and 7.
Notes:
, Recording under insufficient lighting may result
in blurred images. It is recommended that you
use a tripod to record insufficiently illuminated
subjects.
,, Recording under the light of a fluorescent,
mercury, or sodium lamp may cause flickering in
the image and, depending on the timing of the
shot, may result in changes to color hue in the
image.
,, Set the BEEP menu item to "OFF" to turn off the
focus locking sound.
Caution:
, Do not turn the power off while the _ indicator
is flashing in step 7.
55