Connectingthe A/V Network(Optional) - Mitsubishi HS-U520 Owner's Manual

_Important:
redcableis for
connecting the right (R) channel and the white
cable is for connecting the left (L) channel.
If your TV has only one (mono) audio inp_lt, connect only the
white (L) output from yo_r VCR.
If you are connecting your VCR to a mono (non-stereo) TV, you
cannot take advantage of your VCR's Hi-Fi sound.
Connect the other ends of this cable to the AUDIO INPUT
terminals on your TV labeled AUDIO IN
Connect a single yellow video cable to the VIDEO OUTPUT
terminal labeled VIDE() OUT on the VC:[_.
BACK PANEL (VCR)
AUDIO VIDEO
R OUT L OU[
®®®
AUDIO OUT R-- --VIDEO OUT AUDIO IN L-_
AUDIO OUT L-- AUDIO Ir,,I R
BACK F'AI'.,IEL CFV)
__.AUDIO IN VIDEO IN
)
--VIDEO IN
0
O Connect the other end of the video cable to the yellow VIDEO
INPUT terminal labeled VIDEO IN on the TV.
) Connectingthe A/V Network(optional)
Some Mitsubishi TVs and VCRs have special input and output
terminals called the "A/V Network." The primary purpose of the
A/V Network is to "pass" remote control codes between Mitsubishi
components. That is, when the A/V Network is connected, you can
point your VCR remote control at the TV, a:ad the TV will "pass"
the commands on to the VCR.
To connect the A/V Network, you will need a cable with a "mini"
jack at both ends. (A mini jack is the kind you find on headphones
for personal stereos.) A cable may be included with your Mitsu-
bishi TV. If not, you can purchase a cable _ith mini jacks at your
Mitsubishi dealer or an electronics store.
17