Mitsubishi HS-U520 Owner's Manual page 47

CH DAY ON OFF
2; MOI7 ll:3Oa I:30pSP
IO TH20 9:00pIO:OOpEP
..... : : SP
: : SP
cancelinga programmed recording
0
Press the MENU button on the remote control. Your VCR will
turn on and the '_CR Main Menu" will appear on your
screen. Use the ADJUST buttons on the remote control to
select "Program to record." Press the ENTER button.
O You will see the "recap" screen. Use the ADJUST buttons to
place the cursor next to the prot_am you wish to cancel.
O Press the CANCEL button. The program is erased.
Press the MENU button once to return to the VCR Main
Menu; press it again to turn off the menus.
using the TIMER RESETbutton
You can use the TIMER RESET button on the rear panel to erase
both the time and all programmed recordings.
To use the TIMER RESET button, press it with a pencil or a ball
point pen. The power will turn off and the clock will reset. All
programmed recording is erased.
Additionally, the TIMER RESET button will reset the on-screen
language you selectecl. The next time you use the menus, you will
have to select the on-screen language. (See page 26.)
loading a tapefor programming
If, after programming, you forget to load a tape, or if you load a
tape with its erasure tab removed, then the prot_ammed record-
ing light and the tape status symbol will flash. A tape witlhout an
erasure tab will be ejected. To correct this, load a tape with its
erasure tab intact, and turn off the VCR.
memory backup
If the VCR is without, power for 30 minutes or less, it will retain
the time and the programmed settings, provided the VCR has
been plugged in for at least an hour before:hand. If the power is
lost for more than 30 minutes, the time and the programmed
settings will be lost.
45