A Channel - Mitsubishi HS-U520 Owner's Manual

Your choices are:
O Se_ _he clock
_Memorize channels
_Important:
Channel 39
No_ in memory
_Important:
Adding and deleting channels
If necessary, you can manually add or delete channels after you
have completed the automatic channel programming.
Before youbegin,you shouldknowhow:
• to view the picture coming from your VCK; (see page 23)
• to use the menus. (See page 26.)
O Make sure that video mute is ON. (See page 30.)
O Set the VCR's input to tuner. I'o do this, press the INPUT
button on the remote control until a channel number appears
on the screen or on the front panel fluorescent display.
O Press the MENU button on the remote control. The '_€'CR
Main Menu" appears on your 3_.
O Press the ADJUST buttons on the remote control to select
"First Time Set-Up." Press the ENTER button.
You will see the "First Time Set-Up" menu. Press the AD-
JUST buttons to select "Add/delete channels." Press the
ENTER button.
If you are recording, playing back a tape, or receiving a video
signal from an external input, then the words "Not available" will
flash and you will see an error message. To correct this, stop the
tape or switch the VCR's input to tuner.
O
You will see the screen for adding or deleting channe]ts. Use
the ADJUST buttons to select the channel r_hat you want to
add or delete. Press the ENTER button to add the channel or
press the CANCEL button to delete it.
@
When you are finished adding or deleting channels, press the
MENU button once to return to the "First Time Set-Up"
menu; press the MENU button a second tirae to return to the
'_VCR Main Menu"; press the MENU button a third tiime to
turn off the menu.
If you use automatic programming again, you will lose all of the
manual changes you made. All of the channels you deleted will be
added; all of the channels you added will be deleted.
Selectinga channel
Now that you have programmed your channels, and added or
deleted some, you will want to be able to select channels. (If you
have not yet programmed your channels, see page 29, "Program-
ming channels automatically.")
There are two ways to select channels: sequentially or directly.
31