Mitsubishi HS-U520 Owner's Manual page 43

0 Channel 2
ODay Monday _7
1 l_3,0_m
Q Stop time
Record speed AUTO
@ Press the ONE KEY PROGRAM button tx, choose the minute
when you wish recording to start. Then, wait for 4 seconds.
The word "Stop time" is highlighted.
(_ Channel 2
(_ Day Monday 17
0 Start time
1 _ : 30\a,m
\ /. /
ORecord speed
@ Press the ONE KEY PROGRAM button to choose the hour
when you wish recording to stop. Then, wait for 4 seconds.
The minute numbers will begin to flash•
Channel 2
Day Monday 17
OSZart time ll_Oam
Xt3_m
AUTO
ORecord speed
0
Press the ONE KEY PROGRAM button to choose the minute
when you wish recording to stop. Then, wait for 4 seconds.
The record speed will flash.
(_ Channel 2
0 Day Monday 17
(_Start time ll:30am
0 Stop time i : 3,0em
@
@
Press the ONE KEY PROGRAM button t_ set the recording
speed. After 4 seconds, the menus will turn off.
When you are finished with all programming, turn the VC,R
power OFF and make sure the programmed recording light is
lit. However, if you have a cable box, leave it turned ON and
tuned to the channel you wish to record. Additionally, if you
are using an A/B switch, remember to .,;et the switch to the
correct position.
The VCR is ready to record what you've progl'ammed.
changing settings whileprogramming
If you make a mistake when using One Key Program:
O
Press the FF or REW buttons on the front panel to select l_he
setting you wish to change. Pressing the :FF button will move
you forward, while pressing the REW button will mow_ you
backward. If you wish to use the remote control, you can use
ENTER to move forward or CANCEL to move backward.
Once you have chosen a setting, you can change it by using
the PLAY/STOP button on the front panel or the ADJUST
buttons on the remote control.
Once you have corrected the setting, press the FF button or
press the ENTER button to resume your place.
41