Mitsubishi HS-U520 Owner's Manual page 15

F>Important:
O Connect the fourth coaxial c able to the"OUT"terminalonthe
A/Bswitch.Connect t heotherendofthis ,.'able t o the"AN-
TENNAIN" terminalonyourVCR.
I_ Whenyouarefinished, g oto page15,"Connecting
t he 'Televi-
sion."
With this connection, :you should set the A/B switch to "B" only
when you are recording a scrambled channel. In that case, you
should set your VCR to record channel 3 (or 4), and manually set
the cable box to the channel you wish to record.
You should leave the A/B switch set to "A" fbr all other situations.
If you have questions concerning your cable system, please
contact your cable company.
With this connection, you cannot record a scrambled channel and
watch a non-scrambled channel at the same time. You also cannot
watch a scrambled channel and record a non-scrambled channel
at the same time.
Connectingotherantennas
If you don't have cable TV, you'll need to connect a regular an-
tenna. Your antenna may have one of two different kind of ends
(called "leads") on it.
The two kinds of leads are:
300-ohm flat twin leads
that look like this ... :
... or a 75.-o1-rn round lead
that looks like this:
Follow the procedures for connecting the kin3 of leads your
antenna has, then go to page 15, "Connecting the Television."
connecting an antenna with a 300-ohrn flat twin lead
(If you have a 300-ohm flat twin lead, you will need to purchase a
300-75 ohm adapter at your local hardware or electronics store.)
0 Disconnect the antenna t_om the back of the TV.
0
Before you can attach the antenna leads to the adapter, you
need to expose a 5/8 inch segment of each lead by scraping off
the plastic covering. Sometimes these leads have "U" shaped
clips that fit around the screw, in which case you will not
need to peel back the plastic.
13