Mitsubishi HS-U520 Owner's Manual page 45

_Important:
_Important:
Notesabout programmedrecording
You cannot use the VCR when the programmed recording light is
lit. If you want to use the VCR before programmed recording
begins, press the POWER button on the remote once. This turns
the programmed recording light off and the VCR on.
If you use the POWER button on the front panel for this purpose,
you will have to press it twice. Pressing it once turns off the
programmed recording light; pressing it a second time turns t:_e
VCR on.
When you are finished using the VCR, turn the VCR power off
again, either with the POWER button on tile remote or the
POWER button on the front panel. Make sure the programmed
recording light is back on.
After a program has been recorded, the VCR memory is cleared
(unless you have scheduled the VCR to record the program every
day or every week).
If there is already a program in the VCR's memory, you will see
the "recap" screen when you bring up the menus for programrning
to record (unless you are programming with the QUICK PRO-
GRAM button). If the VCR's memory is full, you must era,;e a
program before you can enter a new one.
If a tape runs out during programmed recording, the VCR ejects
the tape and the programmed recording light and the tape status
symbol will flash. Load a new tape and press the REC button. The
VCR will resume recording. Do not overlap the recording times
you program.
Remember that when your VCR is off, it may also be in stand-by
for programmed recording. Also remember that the VCR, wh_,n
programmed, will record over the next section of tape. So, to avoid
recording over tapes you want to save, remember that the VCR
automatically shuts off during OTR recording and auto power
saving. •
Your VCR will not record over a tape that has the erasure preven-
tion tab removed (see "Preventing accidental erasure"). All rental
movies have this tab removed, so they are sa_e fl"om being acci-
dentally erased.
autospeedprogramming
Use auto speed programming if you want to record as much of the
program as possible in standard play (SP) speed, but you vcar_Lt
the VCR to automatically switch to extended play (EP) if there is
not enough tape left.
Auto speed programming is only available in one prograrnming
slot. In the firs_ slot, the recording speed is; automatically set to
43