Fresh Food; Ice And Water - Maytag PSD243LGRW-PPSD243LGW0 Owner's Manual

L TBULBS
FRESH FOOD
Locate finger gaps on each side of
clear light shield. Insert fingers and
press in on each side of shield. Pull
shield down and remove.
Remove light bulbs.
Replace with appliance bulbs no
greater than 40 watts.
Replace light bulb cover by inserting
front tabs of light shield into holes in
liner directly in front of light assembly.
Snap back of light cover into place.
FRESH FOOD
This light is also found in the freezer
section if the model does not have an ice
and water dispenser.
NOTE: Before removing freezer light
cover, remove all surrounding shelving
using instructions in the Freezer Features
section.
Pinch bottom tabs (A) on light cover
and pull straight out.
Remove light bulb.
Replace bulb with appliance bulb no
greater than 40 watts.
Insert top tabs (B) of light cover into
refrigerator liner and snap bottom por-
tion over light assembly.
!Y
A
(DISPENSER MODELS ONLY)
Remove ice bin by lifting front of bin
and pulling out.
Remove light bulb cover by pinching
top tab (A) and pulling cover out of
liner.
Replace bulb with appliance bulb no
greater than 40 watts.
Insert top tabs (B) of light cover into
refrigerator liner and snap bottom por-
tion over light assembly.
Replace ice bin by sliding in until bin
locks into place.
A
fi
ICE A ND WATER DISPENSER
Locate light bulb inside top edge of
dispenser frame. Unscrew to remove.
Replace light bulb with a 7 watt, 120 volt
bulb.
]6