Maytag PSD243LGRW-PPSD243LGW0 Owner's Manual page 76

Some installations require door removal
to get refrigerator to final location.
1. Remove toe grille and bottom hinge
covers.
Open both doors 180 degrees, or
as wide as possible to remove.
6. For dispensing models only:
Detach main wire connector harness
and red wire harness.
To detach main wire harness, use a
flat blade screwdriver or fingernail
to press junction point between two
connectors to release.
2. While pinching white collar (A) to the
blue connector (B), pull water line from
connector.
,B
IMPORTANT: When reconnecting water
line, cut off tubing at first available scored
line before inserting into connector collar.
3. Remove top hinge cover by removing
Phillips screw.
4. Close doors.
5. Unscrew _6" hex head screws from
top hinges.
For dispensing models only:
• DO NOT remove either green
ground wire or wire connecting
center screw.
To detach red wire harness, press
tab on underside of connector to
release.
7. Remove top hinges along with doors.
8. Remove bottom hinges with a _8"hex
head driver.
THE D OORS
To replace the doors, follow the steps
in Removing the Doors and Hinges
in reverse order.
IMPORTANT: When reconnecting water
line, cut off tubing at first available scored
line before inserting into connector collar.
3