Fresh Food Features - Maytag Ice2O Series Use & Care Manual

Fresh F ood Femures
Shelves
Spill-Catcher
TM
Glass Shelves
Your refrigerator has Spill-Catcher
TM
glass shelves. The
shelves have a spill retainer edge which allows for
easier clean up and some are equipped with a slide
out feature. To slide out, grasp the front of the shelf
and pull forward. Push in the shelf to return to the
original position.
To Remove a Shelf:
• Slightly tilt up the front and lift up
the rear of the shelf, then pull the
shelf straight out.
To Lock the Shelf into Another
Position:
• Tilt up the front edge of the shelf.
• Insert the hook into the desired frame openings and
let the shelf settle into place.
• Be sure the shelf is securely locked at the rear.
Elevator
TM
Shelf
The Elevator
TM
Shelf is equipped with a spill-retaining
edge and the EasyGlide
TM
slide-out feature. It can be
adjusted up or down without unloading.
To Slide Out EasyGlide
TM
Shelf:
• Grasp the front of the shelf and pull forward.
• Push the shelf in to return to original position.
To Adjust the Elevator
TM
Shelf:
• Pull out the knob on the crank handle.
• Rotate the crank clockwise to raise the shelf, and
counterclockwise to lower the height of the shelf.
To Remove Elevator
TM
Shelf:
• Completely unload the shelf and pull the shelf
forward.
Pull until the shelf stops.
Slightly tilt up the front and pull the shelf straight
out. Continue pulling forward until the shelf is clear
of the frame.
To Replace Elevator
TM
Shelf:
• Align the shelf to the frame and push it all the way
back.
In ordinary use, the Elevator
TM
Shelf frame assembly
does NOT require removal. Though unlikely, and not
recommended, the correct removal procedure is as
follows:
To Remove Frame Assembly:
• Unload the shelf completely.
• Slide the shelf forward about 2" and manually move
the two rear latches toward the shelf center.
• While supporting the entire shelf and frame from
underneath, lift slightly and rotate the assembly
approximately 30 ° to allow the rear mechanism to
clear the vertical rear side rails.
• The entire assembly can then be moved forward and
clear of the refrigerator compartment.
To Reinstall Frame Assembly:
• Reverse the removal procedure. Be sure the shelf is
in a level position. When the sliding shelf is pushed
to the rear, it will reposition the rear latches to their
correct operating position.
(style may vary)
FrameAssembly
Slide Out
EasyGtidd '' Shelf
16