Materials Needed - Maytag PSD243LGRW-PPSD243LGW0 Owner's Manual

If installing handles for the first time, the
fresh food handles can be located within
the fresh food section. The handle trim
will be located in the literature pack.
Remove two ¼" hex nut screws from
bottom of refrigerator and freezer
door.
Removing handles may be necessary
when transporting unit through tight
spaces.
Remove bottom portion of handles with
a very small flat-blade screwdriver.
IMPORTANT: Wrap blade of screwdriver
with masking tape to avoid damaging
unit.
i iiii
Align door handles with top and bot-
tom sets of door clips, and slide down
until screw holes on bottom of handles
match with door screw holes.
Insert ¼" hex nut screws previously
removed into screw holes at bottom of
handle section.
Snap trim over bottom portion of han-
dles and retainers on bottom of door.
t!
Remove two handle base screws.
Pull handle up and out to release from
unit. Fit may be tight.
MATERIALS NEEDED:
• _" hex head driver
• Level
Remove toe grille and bottom hinge
covers (see previous instructions).
Turn both front adjustment screws (A)
clockwise to raise and counterclock-
wise to lower.
O
A
Turn both rear adjustment screws (B)
clockwise to raise and counterclock-
wise to lower.
Check with level to verify Y4" tilt to the
back for proper door closure.
• If unit is aligned and stable, replace
toe grille and hinge covers.
4