To prevent the cooktop from discoloring
* Clean cooktop after each use.
* Wipe acidic or sugary spills as soon as the cooktop has
cooled as these spills may discolor the
Unlike a range with standard gas burners,
this cooktop does not lift-up nor is it
removable. Do not attempt to lift the
cooktop for any reason.
The sealed burner bases of your range are secured to the
cooktop and are not designed to be removed. Since the
burners are sealed into the cooktop, boilovers or spills will not
seep underneath the cooktop.
However, the burner base should be cleaned after each use.
The cap portion of the burner is easily removed for cleaning.
(See page 17 for cleaning directions.:)
Burner caps must be correctly placed on the burner base for
proper operation of the burner.
There is one 16,000 BTU* high speed burner located in the left
front position on your range. This burner offers higher speed
cooking that can be used to quickly bring water to a boil and for
This burner is located in the right rear position. The simmer
burner offers a lower BTU flame for delicate sauces or melting
BTU ratings wi// vary when using LP gas.
The grates must be properly positioned before cooking. Lower
the grates onto the range so that the bars match up and the
rubber feet located at the four corners of the grates sit in the
indentationson the cooktop.
Improper installationor removal of the grates may result in
chipping or scratching of the cooktop. It may also cause pans
to be unsteady on the grates.
Do not operate the burners without a pan on the grate.
The grate's porcelain finish may chip without a pan to
absorb the heat from the burner flame.
Use care when stirring food in a pot/pan sitting on the burner
grate. The grates have a smooth finish for ease of cleaning.
The pot/pan will slide if the handle is not held. This may result
in spilling of hot food items and may be a burn hazard.
Although the burner grates are durable, they will gradually
lose their shine and/or discolor, due to the high temperatures
of the gas flame.
* A properly adjusted burner with clean ports will light
within a few seconds. If using natural gas, the flame
will be blue with a deeper blue inner cone.
If the burner flame is yellow or is noisy, the air/gas
mixture may be incorrect.Contact a service technician
to adjust. (Adjustments are not covered by the war-
With LP gas, slight yellow tips on the flames are
acceptable. This is normal and adjustment is not
* With some types of gas, you may hear a "popping"
sound when the surface burner is turned off. This is a
normal operating sound of the burner.
If the control knob is turned very quickly from High to
Low, the flame may go out, particularly if the burner is
cold. If this occurs, turn the knob to the OFF position,
wait several seconds and relight the burner.
* The flame should be adjusted so it does not extend
beyond the edge of the pan.