Conventional Surface Burners; Sealed Surface Burners - Maytag Gas Range User Manual

SURFACE COOKING
SEALED SURFACE BURNERS, Jf equipped
The porcelain on the burneris durablebutmay gradually
Undernocircumstances a rethe surfaceburnerassemblies loseitsshinedueto usageand hightemperatures.
tobetakenapartforcleaning. T he surfaceburner assembly
can be removed to cleanthe burnerboxarea. The sealedsurfaceburners aresecuredtothe cooktop and
are NOT designed to be removedby the consumer.
The two surface burnerassembliesare securedin place
duringtransportation withspringclips.Oncethe rangeis Select modelsfeature two specialSUPER HIGH SPEED
installed, t hese clipsmay be removedto allowquickand sealedburnerslocatedat the right-frontand left-rear. Use
easyremovalofthe burnerassemblies, theseburners toquickly bringwatertoa boilandwhenusing
largerpans.See information on ratingplate,locatedonthe
lower range front frame behind the broiler door or lower
___ panel,to determineifyourappliancefeaturestheseburners.
Clean burner cap after each use especially if a spillover
occurs.A soiled burner may result inimproperignitionor an
uneven flame. When cleaning the sealed surface burner,
_'______'\ usecare to preventdamageto the ignitor.If ac leaning cloth
should catch the ignitor,it could be damaged or broken.
Lip
Toremove: Allow burnersto cool.Lift upthe cooktop.Grasp /_ _ Ports
burner assemblythen lift upand toward backof the cooktop /_ .,__ Ignitor
until the air shutter ends on the burner assembly release
from the valves.
To replace: Insert the air shutter ends on the burner _ -- _- Portdirectly belowignitor
assembly over the valves and lower into place. Replace
cooktop.Turn on each burner to be sure burner assembly
has been correctly replaced. The surface burner will not light if the ignitor is damaged,
broken, soiled or wet. The burner will also not light if the
ports, especially the small port located directly below the
ignitor,are blocked. See page 16for cleaning instructions.