Care And Cleaning; Beater To Bowl Clearance - KitchenAid KSM7581BZ0 Instructions And Recipes Manual

Care and Cleaning
Bowl, coated metal flat beater,
stainless steel wire whip, and coated
metal spiral dough hook may be
washed in an automatic dishwasher.
Or, clean them thoroughly in hot
sudsy water and rinse completely
before drying. Do not store beaters
on shaft.
NOTE: Always be sure to unplug
stand mixer before cleaning. Wipe
stand mixer with a soft, damp cloth.
Do not use household/commercial
cleaners. Do not immerse in water.
Wipe off beater shaft frequently,
removing any residue that may
accumulate.
Beater to Bowl Clearance
Your Stand Mixer is adjusted at the factory so the flat beater just clears the
bottom of the bowl. If, for any reason, the flat beater hits the bottom of the
bowl or is too far away from the bowl, you can correct the clearance easily.
1. Unplug Stand Mixer.
2. Place bowl lift handle in down
position.
3.
4.
5.
Attach flat beater.
Adjust so flat beater just clears
bottom surface of bowl when in
lifted position by turning screw (A)
counterclockwise to raise the bowl
and clockwise to lower the bowl.
Just a slight turn is all that is
required: the screw will not rotate
more than 1/4 turn (90 degrees)
in either direction. (The full range
of adjustment is 1/2 turn, or 180
degrees.)
Place bowl lift handle in up
position to check clearance.
A
Raise Bowl Lower Bowl
I
NOTE: When properly adjusted,
the flat beater will not strike on the
bottom or side of the bowl. If the
flat beater or the wire whip is so
close that it strikes the bottom of
the bowl, coating may wear off the
beater or wires on whip may wear.
6. Repeat steps 4 and 5 if necessary.
12