52
Follow the instructions in Start Here to install Windows NT. As you install the operating
system, select the default responses during the Setup process, except for the following:
u
Install the following drivers from backup diskette when prompted, instead of from the
operating system software CD-ROM:
SCSI adapter driver
Video display driver
Sound processor driver
u
When prompted to select a Setup type, select Custom Setup.
u
When prompted, bypass detection of mass storage devices, and install the SCSI adapter
driver from backup diskette. When presented with a list of Adaptec SCSI controllers,
select the entry for Windows NT 4.0.
u
Allow Setup to configure the network only if the system has an installed network
connector, and only if the system is connected to the network.
u
Create an Emergency Repair Disk when prompted.
After installing the operating system, do the following:
u
Install drivers or other system software from any backup diskettes. System software on
backup diskette is usually more current than system software on the operating system
CD-ROMs.
On a system shipped from the factory without a CD-ROM drive, the system's hard disk
drive contains Windows NT Setup files in the
directory from the system hard disk, you must have access to a Windows NT CD-ROM
to use Windows NT Setup files.
u
Perform any additional installation and configuration tasks described in the Late-
Breaking News document delivered with your system.
u
Configure the system as described in Chapter 3, "Configuring the System."
u
If your system was running Windows NT 4.0 Service Pack software, install this software
after installing drivers and other system software, and after installing any application
software products.
u
If you created a Quick-Fix Engineering (QFE) backup diskette during system
configuration, install the QFE update software. Install QFE software after installing any
Windows NT 4.0 Service Pack software. See the
for more information.
u
You can install additional accessories for the sound processor, available from the
Intergraph Bulletin Board Service (IBBS) or from vendor bulletin boards pointed to by
the IBBS.
:\
386 directory. If you delete the
C
I
.
file on the QFE diskette
README
TXT
386
I
Need help?
Do you have a question about the TD-x20 and is the answer not in the manual?