Engine Maintenance Items; Check Engine Oil Level-Kohler Models; Change Engine Oil & Filter-Kohler Models; Recommended Engine Oil-Kohler Models - Craftsman ZTS 7500 Operator's Manual

Zero-turn rear engine riders with electric start
Hide thumbs Also See for ZTS 7500:
Table of Contents

Advertisement

Available languages

Available languages

Engine Maintenance
items
CHECK ENGINE OIL LEVEL -
KOHLER
MODELS
Service Interval: Before each use, and every 8 hours.
1. Turn the engine off, and set the ground speed con-
trois to PARK. Park on a level surface. Allow the
engine to cool.
2. Clean the area around the dip stick (C, Figure 25).
Remove the dip stick (C) and clean it with a paper
towel.
3,
4.
5.
insert the dip stick back into the engine, and push
firmly into place.
Remove the dip stick and read the oil level. The oil
level should be between the "F" and "L" marks (D). if
not, add oil according to the oil recommendations
chart (Figure 24).
CHANGE
ENGINE OIL & FILTER -
KOHLER
MODELS
Service Interval: 100 Hours.
Oil Capacity:
1.6 Quarts (1.5L) with oil filter change.
Note: Change engine oil while the engine is warm. Run
the engine for a few minutes, then shut the engine off
and allow # to cool
1. Clean the area around the dip stick (C, Figure 25)
and oil drain (A).
2. Remove the oil drain plug (A) and dip stick (C). Allow
ample time for complete drainage.
3. Remove the oil filter (B). Discard the filter.
4. Turn the new filter upside down and fill with fresh
engine oil. Allow the oil to seep into the new filter for
two minutes.
5,
6.
Using a drop of oil on your finger tip, wet the rubber
gasket on the bottom of the new filter.
Dump the oil out of the filter and install the filter on
the filter base. Turn the filter clockwise until the rub-
ber gasket meets the filter base. Then turn 2/3 to 1
full turn more.
7. Reinstall the oil drain plug (A) and route the oil drain
hose along side the engine.
8. Fill the crankcase with oil. See CHECK ENGINE OiL
LEVEL above.
9. Test run the engine to check for leaks. Stop the
engine for 1 minute, then recheck the oil level.
Use oil classified API Service Class SG,
SH, SJ or better with SAEViscosity:
E NIJ,
4 NNII
4ENa
"q
I
J
|
I
°F
-20
0
20 3_2 40
60
80
100
°C -30
-18
-7
o
4
16
27
38
*Recommended: Syntbetic oils provide better starting below -10°F.
Figure 24. Recommended
Engine Oil = Kohler Models
Figure 25. Oil Change - Kohler Models
A. Oil Drain Tube
B. Oil Filter
C. Dip Stick
D. Checking Oil Level
23

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

107.27772107.27774

Table of Contents