Local Settings (Replication); General Settings - HP StoreOnce B6000 Series User Manual

Local Settings (Replication)

This page contains three tabs that show the settings for the local HP B6000 Backup System:

General settings

Bandwidth limiting settings
Blackout windows settings
General settings
Users with an Admin login may edit and maintain these settings. Other users may only view them.
1. Select the General Settings tab.
2. Click Edit to make the fields editable, see table below.
3. Click Apply to apply the settings.
Table 25 General Settings (Replication)
Appliance
Maximum Jobs
Synchronization progress
logging
This shows the name of the appliance and its current status. It also tells you the product class.
You can only edit the appliance name. The default name is the network host name of the
appliance (as configured at installation). You may change this to something that is more
user friendly and will make it easier to identify the appliance on the Management Console
of the local and partner appliances. It may be anything that is meaningful to the user, such
as the geographical location of the appliance.
This is the maximum number of source and target jobs that can run concurrently. If necessary,
you can reduce the default value on this page. You may want to decrease the maximum
source jobs to avoid using too much WAN bandwidth. You may want to reduce the maximum
number of target jobs to avoid overloading the target appliance and reserve appliance
performance, if you are running backups at the same time as replication.
An event is always generated each time a mapping goes out of sync and goes back into
sync. This field applies to periodic sync progress updates whilst the mapping remains out
of sync, which results in emails (if emails are configured), but not SNMP traps. Use these
fields to enable progress logging for Library and Share synchronization and to specify the
Local Settings (Replication) 67