Local Settings (Replication) Tab; General Settings Tab - HP StoreOnce User Manual

Local Settings (Replication) tab

This tab contains three further tabs that show the settings for the local HP StoreOnce Backup system:
General Settings tab (page 50)
Bandwidth Limiting tab (page 51)
Blackout Windows tab (page 53)

General settings tab

Users with an Admin login may edit and maintain these settings. Other users may only view them.
1. Select the General Settings tab.
2. Click Edit to make the fields editable, see table below.
3. Click Apply to apply the settings.
Table 14 General Settings (Replication)
Appliance
Maximum Jobs
Synchronization progress
logging
50 Replication functions
This shows the name of the appliance and its current status. It also tells you the product class
and the appliance supported protocol versions. The appliance supported protocol versions
shows which versions of replication protocol are supported so incompatible versions will be
visible to the user. Replication auto negotiates to the lowest supported protocol on either
end.
You can only edit the appliance name. The default name is the network host name of the
appliance (as configured at installation). You may change this to something that is more
user friendly and will make it easier to identify the appliance on the Management Console
of the local and partner appliances. It may be anything that is meaningful to the user, such
as the geographical location of the appliance.
This is the maximum number of source and target jobs that can run concurrently. If necessary,
you can reduce the default value on this page. You may want to decrease the maximum
source jobs to avoid using too much WAN bandwidth. You may want to reduce the maximum
number of target jobs to avoid overloading the target appliance and reserve appliance
performance, if you are running backups at the same time as replication.
An event is always generated each time a mapping goes out of sync and goes back into
sync. This field applies to periodic sync progress updates whilst the mapping remains out
of sync, which results in emails (if emails are configured), but not SNMP traps. Use these
fields to enable progress logging for Library and Share synchronization and to specify the