HP StoreOnce B6000 Series User Manual page 66

Table 24 Source Appliances parameters (continued)
Appliance Status
Appliance Address
Configured Mappings
To add a Source Appliance (administrators only)
There is a wildcard entry in the Source Appliances list that allows you to set permissions across all
source appliances. However, you are more likely to want to set permissions for individual
appliances.
Click Add. A wizard guides you through the necessary steps to add a new source appliance to
the list. You will need to provide the serial number of the appliance and can also specify initial
access permissions for all libraries and all shares on that appliance.
To enable permissions (administrators only)
1. Select the source appliance in the list. There are two tabs; one for Libraries and one for Shares.
2. Click Edit. You can now check the Access box for those shares and libraries to which access
should be granted. These are the shares and libraries that will be displayed when the mapping
configuration step is run in the Replication wizard. It will not be possible to create a new share
or library from the wizard.
3. Click Update to apply the permissions.
66 Replication
This is the status of the appliance for which you have specified the serial number and
cannot be altered.
This is the address of the appliance for which you have specified the serial number and
cannot be altered.
This checkbox indicates whether any mappings have been configured on the source
appliance. This is important to know, because any mappings that already exist will be
retained regardless of any access permissions you subsequently set up for libraries and
shares on that appliance.