3.
Enter the appropriate details in the Device Details tab and click Create. The Cartridges tab is
only generated after the library is created. The information on the Interface Information tab is
normally generated automatically.
See also
Guidelines on creating libraries
There is a maximum of 48 virtual devices per service set. This number may be split across VTL,
NAS and Catalyst devices. The following table illustrates some possible configurations. For more
detailed examples refer to the HP B6000 Series Best Practices Guide.
Table 9 Maximum number of virtual devices per service set
VTL
48
0
0
24
1
47
30
12
16
4
To edit library details (administrators only)
It is possible to edit some, but not all, device details after creating a library. In particular, you
should be aware of the following:
You can delete cartridges by reducing the number of slots on the Devices page, but this will
only remove the highest—numbered blank slots. Once the Delete operation reaches a slot
number that contains data, it will not allow you to reduce the number further on the Details
page, even if earlier slots are blank. You must first use the Cartridges tab to make the slot
blank.
If you change the cartridge size on this page, this will only change newly-added cartridges;
it does not change the size of cartridges that have already been created.
Device details tab (page
NAS
0
48
0
24
47
0
20
12
16
5
19).
Catalyst
0
0
48
0
0
0
0
12
16
3
Total number of devices
48 (maximum)
48 (maximum)
48 (maximum)
48 (maximum)
48 (maximum)
47 (less than maximum)
50 (more than maximum,
you will not be able to
create devices 49 and 50)
36 (less than maximum)
48 (maximum)
12 (less than maximum)
Libraries
21